Black Horse P-47 Thunderbolt 60cc?
#201
#203
Thread Starter
Here are some shots of the BH 60cc P-47. Two pieces wings are great for warbird of this size. As usually there are some blemishes such as paint scheme or flap angle indicator on flaps. But the weathering on self adhesive covering is nice. I was suprised, that she is not covered by oracover or solarfilm but by some self adhesive coat. I am going to replace the cockpit and some other parts such as dummy radial engine and wing pylons.
The following users liked this post:
RoysterDW (03-17-2022)
#205
Thread Starter
#206
#207
Thread Starter
#210
The side panels are not done yet, but I did some progress. I spent some time with new design of the throttle lever. The new one is more detailed and also designed for gyroscopic gunsight.
The following users liked this post:
RoysterDW (03-26-2022)
#216
Thread Starter
Not sure. It’s sandwich of ply and a composite material of some kind. They have also sheeted the inside with some kind of covering.
the retract controller is labeled Phoenix which proves it’s from the same factory as Phoenix.
the retract controller is labeled Phoenix which proves it’s from the same factory as Phoenix.
#219
#220
Senior Member
Too thick to not have some kind of sheeting ubder the iron on. Look at fuselage edges.
yes, theres lightening cutouts but ...looks real good, potentially a good structure. As long as glue joints are good, it should be strong.
What does the engine box look like?
yes, theres lightening cutouts but ...looks real good, potentially a good structure. As long as glue joints are good, it should be strong.
What does the engine box look like?
Last edited by Txmustangflyer; 03-26-2022 at 03:48 AM.
#225
But on the bottom among formers I see only covering.
Last edited by Prekin; 03-26-2022 at 09:29 AM.