Black Horse P-47 Thunderbolt 60cc?
#334
My Feedback: (48)
Well I have decided to do my retracts different. The axle strut to the inside is more like a Zero. I reversed my axle strut to the outside like the the stock P47. I then taped mounting holes for the wheel cover. I can close the minor gap by placing washer under flange at each end mounting bolt. Could shave axle strut but I’m ok with at this time until after Maiden.
#336
My Feedback: (48)
Admiral GP60-8925 electric brushless. Originally set it up with a DLE-55 but switched to electric. Less vibration strain on airframe and ease of use.
I have added shims at back of retracts to close gap. I had to shim each retract a bit different to maintain the same strut angle. I had to do this as there was a slight difference in the total retract angle of each retract.
Blemishes and holes will be corrected. I will also paint the black flange at wheel opening to color match for a much better look. I will not use the plastic liners but will paint inside of each wheel well.
I have added shims at back of retracts to close gap. I had to shim each retract a bit different to maintain the same strut angle. I had to do this as there was a slight difference in the total retract angle of each retract.
Blemishes and holes will be corrected. I will also paint the black flange at wheel opening to color match for a much better look. I will not use the plastic liners but will paint inside of each wheel well.
Last edited by dmyers0403; 06-12-2023 at 12:12 PM.
#337
#338