Twin Jet Setup
03-29-2023, 03:32 AM
#1
Twin Jet Setup
Hello,
I have two Jetcat P250 Pro-S, I have connected the throttle with the "Y" method. The start-up and test runs of the jets were successful.
I have read in the manual that there is a way that I can connect both turbines with TX RX cable, so they can communicate in order to resolve any thrust differential issues.
I wired the 2 ECUs together with the TX RX cable, enabled Engine crosscheck and I made one primary and one secondary engine. But when I try to start-up the turbines, one with Immediate startup and the second one with sequence, one engine stays at LearnLO without giving me throttle authority.
Any ideas?
Kind Regards,
M.
I have two Jetcat P250 Pro-S, I have connected the throttle with the "Y" method. The start-up and test runs of the jets were successful.
I have read in the manual that there is a way that I can connect both turbines with TX RX cable, so they can communicate in order to resolve any thrust differential issues.
I wired the 2 ECUs together with the TX RX cable, enabled Engine crosscheck and I made one primary and one secondary engine. But when I try to start-up the turbines, one with Immediate startup and the second one with sequence, one engine stays at LearnLO without giving me throttle authority.
Any ideas?
Kind Regards,
M.
The following users liked this post:
mhpverheggen (03-29-2023)
